Aeromodel Motor Bonded NdFeB Magnet Tile Arcs Mixed with Epoxy Resin, Comression molding Embedded Neodymium Permanent Magnet, high performance polymer Magnet Assembly with Bonded Magnets, Plastic Bonded Magnet Compound, Bonded Precise dimension Nd magnet, Overmolded or insert molded assemblies magnets for Generator rotor motor, Nd-Fe-B radial ring magnet Supplier
Aeromodel Motor Bonded NdFeB Magnet Tile Arcs Mixed with Epoxy Resin Description :
Shape customized
Grade customized
Size customized
plating not
Material: Bonded Nd magnets
application: Aeromodel Motor, Generator
The product can be customed by your requirement.
Compression molded magnets are made by first mixing the magnetic powder with the polymer binder and then by compressing the mixture in a press mold. These magnets exhibit a higher level of performance than the injection molded couterparts due to higher density.
Compression molded magnets assembled with shaft, yoke and other parts.
Features of compression molded magnets
Highest level of magnetic performance among Nd-Fe-B isotropic bonded magnets.
Since these are isotropic in nature, any magnetization patterns can be used. This is especially advantageous to multi-pole magnetization.
Thin wall thickness (minimum 0.3 mm) can be produced. Inductor Injection Molding Nd Magnet for Embedded Permanent Magnet Synchronous
Excellent corrosion resistance is realized by Daido original coating technology.
Bonded NdFeB magnets are usually made of NdFeB alloy powder mixed with epoxy resin and pressed. They can also be mixed with plastics and molded by injection or extrusion. It has the following characteristics:
1. High magnetic properties: the magnetic properties are between sintered NdFeB magnets and ferrite magnets, with better consistency and stability.
2. High dimensional accuracy, large degree of freedom: product shape and size are determined by the mold. It can be made into ring, tile, block and other free shapes without sintering and post machining.
3. Good corrosion resistance: after surface coating or some special treatment, it can be used in daily or bad environment for a long time.
4. There are various ways of magnetization: the pole can be charged into multipole, oblique pole, end face magnetization, etc., and the waveform can be square wave and sine wave.
5. Injection magnet is more suitable for integral forming of magnetic components, suitable for mass production and high production efficiency. DC Motor Bonded NdFeB Tile Arc Magnets for Household Appliances
Coating method |
Coating thickness
(µm) |
Corrosion resistance
Time to rust formation in humidity test (hours) |
Application shape |
60℃×95%R.H. |
80℃×95%R.H. |
Resin coating |
Electrodeposition coating (epoxy) |
20 ~ 35 |
500 |
300 |
Various shapes |
Spray coating (epoxy) |
15 ~ 30 |
400 |
200 |
Various shapes |
Dip coating (epoxy) |
1 ~ 5 |
100 |
50 |
Small parts |
Barrel spray coating
(epoxy) |
3 ~ 18 |
200 |
100 |
Small parts |
Metal plating |
Ni plating |
10 ~ 30 |
500 |
300 |
Various shapes |
Related