Disc Magnetic Proximity Sensor Magnet N35SH D4 x2mm

/Disc Magnetic Proximity Sensor Magnet N35SH D4 x2mm
  • Disc Magnetic Proximity Sensor Magnet N35SH D4 x2mm
Primary Competitive Advantages:
  • We are A Professional Permanent Magnets & Magnetic Assemblies Company Operating Since 2004
  • All Magnetic Grade for Sintered & Bonded Magnets
  • Our Quality Guaranteed
  • We Ship Worldwide
  • Small Orders Accepted
  • OEM Design Approvals
  • All Payment Accepted
  • Disc Magnetic Proximity Sensor Magnet N35SH D4 x2mm, Precision Neodymium Magnet Disk Sensor, Hall Effect Switches and Magnetoresistive sensors Super NdFeB Magnet, Rare earth disc magnets for Magnet Detecting Speed Sensors, Reed Switch sensors

    Disc Magnetic Proximity Sensor Magnet N35SH D4 x2mm Technical Introduction
    Item No.: MPSNM-0402
    Magnet Size: 4mm x 2mm
    Tolerances: ±0.004″
    Material: Rare Earth NdFeB
    Grade of Neodymium: N35SH
    Plating/Coating: Ni-Cu-Ni
    Brmax: 8,900Gauss
    BHmax: 35 MGOe
    Max Temperature: 150℃
    Magnetization Direction: Axial or Diametrical
    Surface Gauss: Gauss

    Speed Switch Sensors provide one digital pulsing speed output and a high/low or open/close speed switch output that turns on/off dependent on whether the speed is above or below the defined frequency.
    Analog Magnetic Sensors
    MPCO Magnetics offers a wide variety of analog output Hall Effect sensors for detecting the proximity, position, or alignment of a magnet relative to the sensor. Sintered ferrite permanent multipole magnet rings
    Analog Hall Sensors provide a single analog output that increases or decreases dependent on the size and pole of the magnetic field at the face of the sensor.

    Linear Position Sensing Systems combine a sensor and a specially designed target magnet to provide an analog output that changes based on the alignment of the sensor and the target magnet.
    Angular Position Sensors provide a single analog output that increases or decreases dependent on the rotation of an Angle Position Magnet.
    Magnetic Tape Tracking Sensors provide a combination of analog and digital outputs to provide feedback to automated guided vehicles to keep them centered over magnetic tape

    Hall Effect Switches and Magnetoresistive sensors provide a single digital switching output (or relay output) that turns on when a magnetic field is present and then off when the magnetic field leaves. When paired with magnets these sensors can be used to measure speed or count or to confirm a position or alignment between the sensor and target magnet.Magnetic Hall Effect Sensor Magnet

    error: Content is protected !!